You are here:  Home >> Maintenance and repair >>  Repair leaks hunting the most common water
Repair leaks hunting the most common water In the category Maintenance and repair Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail in regards to Repair leaks hunting the most common water.
The flush works with a fairly simple system that is to contain the water in a tank before ejecting with a force of a certain intensity . But the wrong settings or failures of its components may prevent proper operation. To be able to solve this problem, it is necessary to distinguish the different elements because this is how we managed to identify the source of the leak and repair .

The leak is the main problem that affects the operation of a flush because it reduces the ability of the subject useful water to completely empty the toilet bowl . To remedy this relatively common problem , we must first determine the cause before choosing the appropriate solution. With basic tools such as a wrench, a screwdriver and a wrench or power strips claw clip , you can fix leaks .

The different elements of a flush



Viewed from outside, the flush comes down to a single block consisting of a reservoir covered with a lid surmounted by a handle or button. Its water supply is provided by a shut-off valve connected to a filling pipe and a float valve actuated by a float . At the bottom of the tank is the mechanism of the flush valve consists of a set on his head , a seal tank bottom and a bell and a valve stem attached to the axis of the handle . At the duct connecting the flush cup and there is a seal secured by bolts used to seal the reservoir.
The detection of sources of water leaks must also go through the understanding of the roles of the elements of the device. Apart from those who are called standard , most flushing current feature qualified mechanism cluck -tock , others are equipped with silent float valve and you can also find those that have a tank to disinfectants .

How to repair a leaking flush ?



When flush leaking, the first source of the problem may be at the float may have a default setting causing leakage through the overflow . This problem is repaired by adjusting the water level depending on the material with which the arm of the float is made . If copper , simply twist it to have good water , but sail is plastic level, we must bring the float to the end of the shaft . Leakage of flushing may also occur as a result of perforation of the float, which is then deposited continuously at the bottom of the tank. In this case, it must be replaced by removing the old part and fit the new , but if you can not remove it, you must change the entire float with his cock .

If the leak is not related to the cases cited above, it may come from another source . To determine its source, it pulls up the float up , but if the water level in the tank continues to rise and escape through the overflow persists, we can conclude that the problem is valve tap float which must be replaced . You can use a wrench to loosen the nut on the pipe located at the float valve after closing the stopcock , then replace the valve by lifting the valve and the float arm . When it is dismantled , it must be separated from the whole by removing the little pin that secures the arm to evacuate the seal carrier .

Otherwise leak flush



The problem of flushing can also come from the failure of the valve mechanism which is manifested by the leakage of water into the bowl through the bell. This case can be remedied by cleaning the valve and its seat by removing the whole mechanism . This is usually done with water added vinegar to possibly dislodge limestones deposited on parts . Finally, we back all elements of the mechanism in place and make the dressing .

The latter problem of causing a leak of water flush is the deterioration of the seal of the reservoir which causes the flow of water outside the tank bottom . We must therefore change the seal by removing the tank. To loosen the two bolts that secure , it must first be emptied after closing the stopcock. When fully removed , the lid and the handle is removed and this is how we can begin to unscrew the nut securing the mechanism, the back tank. This will loosen the nut on the outside of the tank with a clamp power strips , then the mechanism of flush in order to replace the seal and finally is removed, gives up all correctly the elements prior to the running mixer.
Repair leaks hunting the most common water