You are here: Home >> Maintenance and repair  >>  home electrical distribution system  >>  How to change the console in a hot water heater
How to change the console in a hot water heater
HOW TO CHANGE A CONTROLLER IN A HOT WATER HEATER In the category Maintenance and repair Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail in regards to HOW TO CHANGE A CONTROLLER IN A HOT WATER HEATER.

How to change the console in a hot water heater



The temperature of your water heater control is based on the power to the thermostat. A water heater thermostat works in the same way that a thermostat works to control the temperature of your home, the regulation of the heating elements in the system. When a hot water heater is no longer the production of water at acceptable temperatures, it is a clear indication that the thermostat needs to be changed.
Look for the model number of your hot water heater. This information is located in the documentation accompanying the water heater or directly from the unit once the access panel is removed. To remove the access panel, inspect the unit during a screwed in panel. Use a screwdriver to remove the panel and enter the model number. This ensures that you find a compatible thermostat in the purchase of a new one.

Buy your new thermostat using the information in the model number of the stage 1.

Turn off the power to the hot water heater. Turn off the circuit breaker, which is normally found in the garage. Unplug the unit from the wall if it is electric.

Drop wires located in the interior of the panel that you extracted in step 1. The wires are fed into the old thermostat and screws hold the wires in place.

Unscrew the thermostat of the mount. Discard the old thermostat. Place the new thermostat on the mounting and screw in place. Connect the wires to the new thermostat in place by screwing.

Adjust the thermostat to the intensity of the hot water that you prefer. Most thermostats are set at 108 degrees Fahrenheit.

Replace the access panel. Place the unit and the screw access panel in place. Plug the unit back to exit and restore power to the water heater hot circuit breaker that you disabled in step 3.
Test the water. After allowing the unit to turn on, give your new thermostat 10 to 20 minutes to heat the water to the desired temperature. Test the water of any sink or shower in the House. If the water is hot, that it has successfully replaced the control. If the water does not heat, check the connections to the wiring of the thermostat and hot water heater.

Related searches
electric hot water tank controls
smart hot water heater controller
electric hot water heater controller
remote hot water heater control
hot water heater wifi controls
water heater wifi control
gas water heater controller
wifi electric water heater controller.

YOU MIGHT ALSO LIKE

← Previous Post                                                  Next Post →
Comments & Responses

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment
Name *
Email *
Website