error codes Candy washing machines

error codes Candy washing machines In the category washing machine error codes Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail more articles and learn more information about error codes Candy washing machines.
error codes Atlant washing machines

The error codes Atlant washing machines door - It's simple : the problem with the door - you can close it Read more

error codes Gorenje washing machine

The error codes Gorenje washing machine Video repair Gorenje washing machine Replacement parts in a Gorenje washing machine F1 - CM tries to tell you Read more

error codes Hansa washing machines

The error codes Hansa washing machines  Video repair Hansa washing machines Replacement parts in a Hansa washing machines CM series RA E01 - Faulty door Read more

error codes KAISER washing machines

The error codes KAISER washing machines  Video repair KAISER washing machines Replacement parts in a KAISER washing machines E 01 - The system has not Read more

The error codes Candy washing machines 

Diagnosis of Candy washing machines

Video repair Candy washing machines

Replacement parts in a Candy washing machines

Repair of Candy washing machines  with their hands

E01 – The system has detected a malfunction of the door lock device CM ( the door is not locked , the indicators do not light up )
E02 – The signal problems in the system loading of water ( the water level reaches or exceeds the nominal ) and fault valve clogged filter
E03 – The signal problems in the drain water (draining missing or timed drain )
E04 – The signal problems in the system loading of water ( the water level within the set limits )
E05 – The system indicates problems with temperature sensor – no hot water , washing stops
E07 – The system indicates problems drive motor – tachometer error
E09 – The system indicates problems drive motor ( not rotating shaft) – management problems
E10 – Faulty program selector or motor connections
E12 – Loss of communication between the control unit and display
E13 – Loss of communication between the board and display
E14 – (MDL) is faulty control unit or its compounds (INVENSYS) defective PETN
E15 – Faulty control module , control module program crashes
E16 – Short-circuit , insulation damage
E17 – Incorrect signal from tacho
E18 – Faulty control module , incorrect parameters supply mains

Candy Grand’O GOF822 Washing Machine

Leave a Reply

Your email address will not be published. Required fields are marked *